COMP:定义补偿器(Define compensator)
COMP用来定义表面编号和补偿器的类型,以供分析公差使用。Int1用来指定表面,Int2用来定义类型。Int2使用的定义“代码”如下所示:
Int2=0,补偿器为厚度。
Int2=1,补偿器为曲率半径(超过1代表半径)。
Int2=2,补偿器为圆锥曲线。
也可以参考第528页“关于补偿器最小和最大值的粗略注释(General comments about mina and max values on compensators)”。